Hide Table of Contents

Surface Face Fillet

To create a face fillet between surfaces:

  1. Create two surfaces (the surfaces need not be adjacent).

     

  2. Click Fillet on the Features toolbar, or click Insert, Surface, Fillet/Round.

  3. In the PropertyManager, under Fillet Type, select Face fillet.

  4. Under Items To Fillet, set a Radius value.

  5. Select the first face to fillet in the graphics area for Face Set 1. The preview arrow indicates the direction of the face fillet.

  1. Click in Face Set 2, then select the second face to fillet in the graphics area. If necessary, click Reverse Face Normal so the arrows point towards each other.

  1. Set the other PropertyManager options. Under Fillet Options, the Trim surfaces options apply only to face fillets using surfaces:

    • Trim and attach. Trims the filleted faces and knits the surfaces into one surface body.

    • Don't trim or attach. Adds a new fillet surface, but does not trim the faces or knit the surfaces.

  1. Click OK .

    The face fillet with Trim and attach selected.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Surface Face Fillet
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46