Hide Table of Contents

Tangent Edge Display Overview

Tangent edges are transition edges between rounded or filleted faces in drawing views in Hidden Lines Removed or Hidden Lines Visible display modes. The most commonly seen tangent edges are the edges of fillets. Tangent edges are often visible in pictorial (isometric, trimetric, and dimetric) views, but are removed in orthographic (such as front, right, and top) views.

You can also use part configurations to change the display by suppressing fillets.

Tangent edges can be displayed as follows:

  • Visible - a solid line

  • Use font - a line in the default font defined in Tools > Options > Document Properties > Line Font.

  • Removed - not displayed

  • Hide ends - hides the start and end segments of tangent edges

Visible

Use font

Removed

Hide ends

Other options for tangent edge display are in the Hide/Show Edges PropertyManager.

You can control tangent edge display in the following ways:

  • Default - to set the display for all new drawing views, click Options > Display Style, and choose one of the options under Tangent edges in new views.

  • Views - to set the display for an individual view in a drawing, right-click the view in either the graphics area or the FeatureManager design tree and select Tangent Edge, then choose a tangent edge display mode.

You can set the color of tangent edges in Tools > Options > System Options > Colors. In Color scheme settings, select Drawings, Model Tangent Edges and set the color. The color applies to Tangent Edges Use Font only.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Tangent Edge Display Overview
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.