> Sheet Metal > Patterns of Edge Flanges and Tab Features

What's New: Highlights of SolidWorks 2011

Legal Notices

User Interface

SolidWorks Fundamentals

Drawings and Detailing

Bend Calculation Tables

Convert to Sheet Metal

Flat Patterns

K-Factor in Configurations

Mapping Bend Directions When Exporting to DXF/DWG Files

Mirroring Edge Flanges and Miter Flanges

Sheet Metal Properties

Patterns of Edge Flanges and Tab Features

Patterns of Edge Flanges and Tab Features

You can pattern edge flanges and tab features that have additional sheet metal features attached.

The patterns are supported for the same sheet metal body only. Multibody is not supported. Pattern tools include linear, circular, curve driven, sketch driven, and table driven patterns.

You cannot pattern tab features with attached jogs or sketched bends.

Parent topic: Sheet Metal

Search 'Patterns of Edge Flanges and Tab Features' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Patterns of Edge Flanges and Tab Features
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.