Hide Table of Contents

Example of Multiple Curvature Control

This example of an imported surface has a gap along the front face. To patch the surface correctly, you must apply a different curvature control type to the different boundary edges.

  1. Import model and click Filled Surface on the Surfaces toolbar, or Insert, Surface, Fill.

  1. In the graphics area, under Patch Boundary, select the boundary edges.

  • Apply Contact patch to the two curved edges.

  • Apply Tangent patch to the two horizontal edges.

  1. Click OK to apply Fill Surface



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example of Multiple Curvature Control
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.6