Hide Table of Contents

Miter Flange - Sketch Creation

The sketch for a Miter Flange must adhere to the following:

  • The sketch can contain only lines or arcs.

  • The Miter Flange profile can contain more than one continuous line. For example, it can be an L-shaped profile.

  • The sketch plane must be normal to the first edge where the Miter Flange is created.

To create a sketch for a Miter Flange feature:

  1. Select the first edge in the series of edges where you want to create a Miter Flange feature. Make sure to click the edge near the endpoint at the start of the series of edges.

  1. Click Line on the Sketch toolbar, or click Tools, Sketch Entities, Line.

    A sketch opens normal to the selected edge. The origin of the sketch is at the endpoint of the edge that is closest to where you clicked in step 1.

  1. Sketch the profile of the Miter Flange. Make sure that one line starts at the endpoint of the edge where the sketch origin is located.

    Back to Miter Flange.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Miter Flange - Sketch Creation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53