Hide Table of Contents

Overflow Type

  • Default. The system chooses one of the following options, depending on the geometry conditions (convexity of edges being filleted and the adjacent edges, and so on).

  • Keep edge. Maintains the integrity of adjacent linear edges. However, the fillet surface is broken into separate surfaces, and in many cases the top edge of the fillet may have a dip in it.

  • Keep surface. Uses the adjacent surface to trim the fillet. As a result, the fillet edge is continuous and smooth, but the adjacent edge is disturbed.

 

art\FILLET02_shg.gif

Keep edge

Keep surface



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Overflow Type
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21