Hide Table of Contents

Assumptions of Linear Static Analysis

Linear static analysis makes the linearity assumption, the elasticity assumption, and the static assumption.
Simulation results are invalid if these assumptions are not satisfied.

Linearity Assumption

The induced response is directly proportional to the applied loads. For example, if you double the magnitude of loads, the model's response (displacements, strains, and stresses) doubles. You can make the linearity assumption if the following conditions are satisfied:
  • The calculated highest stress is in the linear range of the stress-strain curve characterized by a straight line starting from the origin.
  • The maximum calculated displacement is considerably smaller than the characteristic dimension of the part. For example, the maximum displacement of a plate must be considerably smaller than its thickness and the maximum displacement of a beam must be considerably smaller than the smallest dimension of its cross-section.

Use nonlinear analysis if the linearity assumption is not satisfied.

Elasticity Assumption

The part returns to its original shape if the loads are removed (no permanent deformation).

Use nonlinear analysis if the elasticity assumption is not satisfied.

Static Assumption

Loads are applied slowly and gradually until they reach their full magnitudes. Suddenly applied loads cause additional displacements, strains, and stresses.

Use dynamic analysis if the static assumption is not satisfied.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Assumptions of Linear Static Analysis
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.