Hide Table of Contents

Optimization in SolidWorks Simulation

You can:


  • Perform optimization analysis on an assembly.
  • Specify up to 20 dimensions as design variables. You can define Simulation parameters and driving global variables as the design variables.
  • Specify up to 60 criteria for the model to satisfy. You can specify any sensor, excluding workflow-sensitive Simulation sensors, as the constraints.
  • Maximize or minimize any quantity that can be defined as a sensor.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Optimization in SolidWorks Simulation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.