Hide Table of Contents

Why Simulate?

After building your design in SolidWorks, you might need to answer questions like:
  • Will the part break?
  • How will it deform?
  • Can I use less material without affecting performance?
Without simulation tools, these questions can be answered only by expensive and time-consuming product development cycles that typically include the following steps:
  1. Build your model in the SolidWorks CAD system.
  2. Prototype the design.
  3. Test the prototype in the field.
  4. Evaluate the results of the field tests.
  5. Modify the design based on the field test results.
This process continues until a satisfactory solution is reached. Simulation can help you accomplish the following tasks:
  • Reduce cost by testing your model using the computer rather than field tests.
  • Reduce time to market by reducing the number of product development cycles.
  • Optimize your designs by simulating concepts and scenarios before making final decisions.

Stress Analysis

Stress or static analysis calculates the displacements, strains, and stresses in a part based on material, fixtures, and loads. A material fails when the stress reaches a certain level. Different materials fail at different stress levels. SimulationXpress uses linear static analysis, based on the Finite Element Method, to calculate stresses. Linear static analysis makes several assumptions to calculate stresses in the part.

Finite Element Method

The Finite Element Method (FEM) is a reliable numerical technique for analyzing engineering designs. FEM replaces a complex problem with many simple problems. It divides the model into many small pieces of simple shapes called elements.
CAD model of a bracket Model subdivided into small pieces (elements)
Elements share common points called nodes. The behavior of these elements is well-known under all possible support and load scenarios. The motion of each node is fully described by translations in the X, Y, and Z directions, called degrees of freedom (DOFs). Analysis using FEM is called Finite Element Analysis (FEA).
A tetrahedral element. Red dots represent the element's nodes. Element edges can be curved or straight.

SimulationXpress formulates the equations governing the behavior of each element taking into consideration its connectivity to other elements. These equations relate the displacements to known material properties, fixtures, and loads.

Next, SimulationXpress organizes the equations into a large set of simultaneous algebraic equations. The solver finds the displacements in the X, Y, and Z directions at each node.

Using the displacements, SimulationXpress calculates the strains in various directions. Finally, the program uses mathematical expressions to calculate stresses.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Why Simulate?
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.