Hide Table of Contents

Using Default Mesh Settings

To accept the default mesh settings (default element size and tolerance values):

  1. Click Run Simulation.

    When the simulation is complete, an animation of the deformed part is displayed.

  2. Click Stop animation or Play animation .
  3. Review the animation and determine whether the loads and fixtures are applied properly.
    • Click Yes, continue if the animation is okay.
    • Otherwise, click No, return to Loads/Fixtures, modify the loads and fixtures, and then rerun the study.
  4. When simulation is complete, a check mark appears next to Run and Results in the SimulationXpress wizard.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Default Mesh Settings
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.