Hide Table of Contents

Route Point

A Route Point is a point in a fitting (flange, elbow, electrical connector, and so on) that is used to position the fitting at an intersection or endpoint in the route sketch.

In a fitting with multiple ports (such as a tee or cross), you must create a sketch point at the intersection of the axes of the fitting before adding a Route Point.

See also Connection Point.

To create a Route Point:

  1. Click Create Route Point art\rtpoint.gif (Routing Tools toolbar) or Routing, Routing Tools, Create Route Point.

  2. Under Selections in the PropertyManager, for Select a sketch point :

  • For rigid pipe and tube fittings, select a sketch point in the graphics area.

  • For flexible tubes fittings or electrical cable connectors, select a sketch point and a planar face in the graphics area.

  • In a fitting with multiple ports, select the sketch point at the intersection of the axes.

  • In a flange, select a point that is concentric with the cylindrical faces of the part. If the flange mates with another flange, select a point on the mating face.

  1. Click .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Route Point
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46