Hide Table of Contents

Flatten Route PropertyManager - Flatten Parameters

Select a route segment, segment center, and define the formboard sketch for a manufacture-style flattened route.

To open the PropertyManager for a manufacture-style flattened route, from an electrical routing assembly, click Flatten Route (Electrical Routing toolbar), and select Manufacture.

Flatten Parameters

Route Sketch Segment Specifies a sketch segment near a route segment end. The segment specifies the flattened route orientation.
Flattened Route Center Specifies the center of the formboard sketch for the flattened route.
Formboard Width Sets the width of the formboard sketch.
Formboard Height Sets the height of the formboard sketch.
Segment Orientation

Horizontal or Vertical

or Applies orientation to the selected segment, or to the segment closest to the center of the route if you do not select a segment.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Flatten Route PropertyManager - Flatten Parameters
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46