Neutral Plane Draft - Face Propagation Examples
Using
as the Type of Draft, you can draft some of the outer faces, all the outer faces, some of the inner faces, all of the inner faces, faces that are tangent, or a combination of both the inner and outer faces. In the PropertyManager, under Faces to Draft, select from the Face Propagation values below.
|
Face Propagation
|
Selection in Graphics Area
|
Draft Results
|
|
None. Only the selected face is drafted. The top face is used as the Neutral Plane in all the examples.
|
|
|
|
Along Tangent. Extend the draft to all faces that are tangent to the selected face. (The faces meet with filleted corners).
The outer faces include any of the faces you select on the base-extrude.
|
|
|
|
All Faces. Draft all faces next to the neutral plane and extruded from the neutral plane.
The inner faces include any faces on the three boss-extrudes.
|
|
|
|
Inner Faces. Draft all inner faces extruded from the neutral plane.
|
|
|
|
Outer Faces. Draft all outer faces next to the neutral plane.
|
|
|