> Design Checker > Dimension Checks > Text Position

Introduction

Administration

User Interface

SolidWorks Fundamentals

Welcome to SolidWorks Design Checker

Overlapping Dimension

Replaced Original Text

Text Position

Dimension Precision

Drawing Document Checks

Part Document Checks

Assembly Document Checks

Feature Checks

Design Studies in SolidWorks

Drawings and Detailing

Sustainability Products

Text Position

Adds text position checks.

To assign checks for text position:

Select Text Position .
Click one value from each of the four dimension text groups:

Linear Dimension Text	Radial Dimension Text

Angular Dimension Text	Chamfer Dimension Text

Search 'Text Position' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Text Position
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.