Hide Table of Contents
CurveChordAngleTolerance Property (ITessellation)

Gets or sets the maximum angle, in radians, that is allowed between a chord and its originating curve.

.NET Syntax

Visual Basic (Declaration) 
Property CurveChordAngleTolerance As Double
Visual Basic (Usage) 
Dim instance As ITessellation
Dim value As Double
 
instance.CurveChordAngleTolerance = value
 
value = instance.CurveChordAngleTolerance
C# 
double CurveChordAngleTolerance {get; set;}
C++/CLI 
property double CurveChordAngleTolerance {
   double get();
   void set (double value);
}

Return Value

Value for the curve chord angle tolerance

Remarks

This angle is calculated as the sum of the two angles between a chord and the curve tangents, measured at the chord ends.

See Also

Availability

SolidWorks 2001 FCS, Revision Number 9.0


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   CurveChordAngleTolerance Property (ITessellation)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.49