Fixed or Floating Position in Configurations
You can configure whether the position of a component is fixed or floating in an assembly.
To fix or float an assembly component:
-
Right-click the component in the graphics area or FeatureManager design tree.
-
Select Fix or Float, and then This configuration
, All configurations
, or Specify Configurations
.
You can also control in a design table whether the position of a component is fixed or floating. The column header uses this syntax:
$FIXED@component_name
The column header is not case sensitive.
In the table body cells, type the value for the desired condition: Yes (or Y) for fixed, No (or N) for not fixed (floating). If a cell is left blank, the default condition is No (that is, floating).
Example of a design table that controls whether the position of a component is fixed or floating:
