Centerline creates construction geometry.
Convert Entities creates one or more entities in a 3D sketch by projecting an edge, loop, face, external curve, external sketch contour, set of edges, or set of external curves onto the sketch plane.
Face Curves extracts 3D iso-parametric curves from faces or surfaces.
Sketch Fillet rounds the intersections of sketched lines.
Sketch Chamfer bevels the intersections of sketched lines.
Intersection Curve creates a sketched curve at intersections.
Trim Entities trims or extends a sketch entity in a 3D sketch.
Extend Entities extends a sketch entity in a 3D sketch.
Construction Geometry converts sketched curves in a 3D sketch to construction geometry.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2012 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.
