Hide Table of Contents

Sketch on the Face of a Part

To create new features on a part, you sketch on the face of the part where you want to locate the feature.

To sketch on model faces:

  1. Select the planar model face on which you want to sketch.

  2. Click a sketch tool on the Sketch toolbar, click Sketch art\EDITMODL.gif, or click Insert, Sketch.

    The following happens:

  • The appropriate sketch tool is displayed, and the sketch is displayed as you drag the tool on the model face.

A grid appears on the face that you selected (if you selected Display grid in Tools, Options, Document Properties, Grid/Snap).

  • The message Editing Sketch appears in the status bar at the bottom of the SolidWorks window.

To sketch on a different face, exit the current sketch, select the new face, and open a new sketch.

You can also use RapidSketch to open sketches on any planar face or plane with an active sketch tool,



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch on the Face of a Part
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21