Hide Table of Contents

Automatic Bonding Between Touching Entities

Enhanced algorithms automatically bond touching entities for the following cases:

  • A face or edge of a shell with a solid.

  • A face or edge of a shell with another shell.

  • A face of a solid or shell with a beam that acts as a stiffener.

  • A face of a solid or shell with a beam joint.

Shells refer to both sheet metals and surfaces. You can apply loads, fixtures, contacts and connectors to the sheet metal and they get transferred to the mid-surface automatically. See Applying Loads and Fixtures to Shells.

All shell edges to faces bonded contacts that are detected by the software are suppressed by default, when you create a new study. Right click item Shell Edge/Face Contact (-Bonded Incompatible-) under Global Contact (-bonded) and click Unsuppress to automatically generate the shell edges to faces bonded contacts. These contact sets are generated in the background and are passed to the solver.

To view or edit the shell edge to faces contact definitions, use instead the option Find shell edge - solid/shell face pairs in the Contact Sets PropertyManager.

For touching faces of sheet metal components that mesh with shells created at mid-surfaces, the program transfers the bonding contact to mid-surface shells automatically.

In cases of bonding contact between sheet metal parts with other surfaces (solids or shells), the bonding algorithm can enforce over-stiffening due to the gap between the mid-surface mesh and the contact surface geometry. The over-stiffening of the bonding contact alters the calculation of the rigid body modes. The program will calculate all rigid modes (with frequency values close to 0), if you eliminate the gap by offsetting the mesh of the sheet metal parts from the mid-surfaces to the contact surface geometry.

Surface edge touching a sheet metal face

Side view of mesh (zoomed)

Sheet metal faces touching each other

View of Mesh at Mid-Surfaces

Solid face touching a sheet metal face

Side view of mesh (zoomed)

Bonding between touching structural members with a sheet metal face is also automatically created and transferred to mid-surface shells.

Structural members touching a sheet metal face

Side view of mesh (zoomed)

Note: You need to manually define bonding for touching non-planar faces that mesh with shell elements. However, automatic bonding occurs for touching edges of surfaces with non-planar faces.

Beam-plate joint

Mesh of the imprinted beam section area on the plate

When beam joints are connected to a neighboring face of a solid or shell, the beam’s actual cross-section is meshed and imprinted on the solid or shell face, creating a more accurate bonding connection.

During meshing, elements are created in the imprinted beam section area. The end beam joint is connected to all elements inside the imprinted section area forming a more realistic representation of the joint.

Touching non-planar faces of shells



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Automatic Bonding Between Touching Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.