Hide Table of Contents

List Fatigue Results

List

Select the result to be listed.

  • Life. Lists the number of cycles required to cause failure at each node. Available only when the fatigue study is defined with one event.

  • Damage. Lists the cumulative damage factor at each node.

  • Factor of safety. Lists the load factor of safety at each node.

  • Biaxiality indicator. Lists the ratio of the smaller alternating principal stress (ignoring the alternating principal stress nearest to zero) to the larger alternating principal stress.

Advanced Options

  • Extremes . Check this option to search for extreme values.

    • Criterion . Sets the criterion for extreme results. Available list options are: Absolute Max, Algebraic Max, and Algebraic Min.

    • Sort by value. If checked, activates the sorting of the list.

    • List all values within. Sets the range of values to be listed. The default is to list values within 5% tolerance of the extreme value.

  • Range . Check this box to specify the desired range of nodes to be searched. Use this option to list values sequentially with node numbers. Enter the lowest and the highest node numbers.

Related Topic

Listing Results



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   List Fatigue Results
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46