Hide Table of Contents

Default Options - Plot - Frequency/Buckling Study

Sets default result templates (folders and plots) for frequency or buckling studies. When you run a study that does not have any existing result plots, the software creates the folders and plots as specified in this page. If you run a study that has valid or invalid plots, the existing plots are updated regardless of the settings specified in this page.

To display the dialog box, click Simulation, Options, Default Options, Plot, Default Plots, Frequency/Buckling Study Results.

  • Create plots for. Specify the mode shapes to be plotted by default.

  • For All mode shapes. Create a plot for each extracted mode.

  • A defined number of mode shapes. Create plots for the specified number of modes. The actual number of created plots is the lowest of the number specified here and the number of actual modes extracted.

  • Results type. Choose the type of plots to be created.

  • Displacement. Plot a displacement component.

Results type

Displacement plots



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Default Options - Plot - Frequency/Buckling Study
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21