Hide Table of Contents

SolidWorks Task Scheduler

The SolidWorks Task Scheduler is available for the following Workgroup PDM tasks:

  • Convert Workgroup PDM Files (vault administrators only). Converts Workgroup PDM vault files that were created at an earlier SolidWorks release to the current release.

When converting Workgroup PDM vault files in SolidWorks Task Scheduler, all documents open in a resolved state (not lightweight). Make sure the computer on which you run the conversion has enough memory to complete this procedure.

You must have a Workgroup PDM client license installed on the computer using the SolidWorks Task Scheduler.

If a selected project uses standard library files from a shared location, these files must be accessible to the computer on which you are running the update.

You log in separately for each type of operation.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   SolidWorks Task Scheduler
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21