Hide Table of Contents

End Treatment PropertyManager

Specify the following properties when you insert an end treatment weld bead in a drawing.

Parameters

ANSI type . Creates an end treatment in the ANSI standard.

ISO type . Creates an end treatment in the ISO standard.

Bead leg length 1 (ANSI type only) . Sets the length of the end treatment for the first edge.

Bead leg length 2 (ANSI type only) . If Equal leg length is cleared, sets the length of the end treatment for the second edge.

Bead throat thickness (ISO type only). Defines the end treatment by setting the throat thickness.

Bead leg length (ISO type only). Defines the end treatment by setting the leg length.

Edges . Displays the weld bead or two edges that create the boundary for the end treatment. You must select two adjacent edges. The symbol is placed at the intersection of the edges.

Display dimensions. Shows the Bead leg length or Bead throat thickness values in the graphics area. Changes to the dimensions change the symbol.

Use solid fill. Displays the end treatment in a solid color. When cleared, the symbol gives a line representation.

Selected

Cleared

Layer

Applies the weld bead to the specified drawing layer.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   End Treatment PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46