Hide Table of Contents

DimXpert Tolerance Options

These options define whether DimXpert uses Block Tolerances or General Tolerances on dimensions that do not contain tolerances.

Methods

Block Tolerance. A common form of tolerancing used with inch units. The tolerance is based on the given precision of each dimension, so you must specify trailing zeroes. In Tools, Options, Document Properties, Dimensions, set Trailing zeroes to Standard.

General Tolerance. A common form of tolerancing used with metric units in conjunction with the ISO drawing standard. General Tolerancing is based on ISO 2768-1 Tolerances for linear and angular dimensions without individual tolerance indications.

Block tolerance

Length unit dimensions. Sets up three block tolerances, each having a number of decimal places and tolerance values. DimXpert applies the Value as a symmetric plus and minus tolerance.

Angular unit dimensions. Sets the tolerance value to use for all angular dimensions, including those applied to cones and countersinks, and angle dimensions created between two features. DimXpert applies the Tolerance value as a symmetric plus and minus tolerance.

General tolerance

Tolerance class. Sets the part tolerance class.

  • Fine

  • Medium

  • Coarse

  • Very Coarse



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   DimXpert Tolerance Options
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21