Hide Table of Contents

Sketch Dimensions in Configurations

You can control the driving state of sketch dimensions in specified configurations to control the behavior of your model.

To control the driving state of sketch dimensions:

  1. Right-click a dimension.

  2. In the Dimension PropertyManager, on the Other tab, under Options, select Driven.

  3. Click Configurations.

  4. In the dialog box, select the configurations you want to apply the new settings to: This configuration , All configurations , or Specify configurations .

  5. Click OK.

  6. Click .

The sketch dimension is driven.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Dimensions in Configurations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46