Hide Table of Contents

Welded Corner PropertyManager

The Welded Corner PropertyManager allows you to add a weld bead to the corners of a folded sheet metal part, including miter flanges, edge flanges, and closed corners.

Corner to Weld

  • Select a side face of a sheet metal corner to be welded . Lists the face to begin applying the bead.

  • Stopping point . Lists the vertex, edge, or face where the bead ends.

  • Add fillet.

    fillet added

    no fillet added

  • Fillet radius .

The fillet radius must be less than a tangent arc connecting the outer edges.

  • Add texture. Adds a texture to the bead for display purposes.

  • Add weld symbol. Adds a weld symbol for the created weld.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Welded Corner PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46