Hide Table of Contents

Example of Loft - Mesh Preview

You can apply a preview mesh on the B-spline (non-analytic) surfaces of lofts to better visualize the loft surface. You can apply mesh to selected faces or to all faces. Right-click anywhere in the graphics area, select Mesh Preview, and select from these options:

  • Mesh All Faces. Adds mesh to all faces

  • Mesh Face. Adds mesh to individual faces

  • Clear all Meshed Faces. Clears mesh from all faces

  • Clear Meshed Faces. Clears mesh from individual faces

Analytic surfaces - no mesh display possible

Mesh All Faces selected with non-analytic surfaces

Clear Meshed Faces selected - Mesh cleared from individual face

Clear all Meshed Faces selected - Mesh cleared from all faces

 

 

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Example of Loft Mesh Preview
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21