Hide Table of Contents

Sheet Metal - Default Bend Parameters

A Sheet-Metal1 feature in the FeatureManager design tree indicates a sheet metal part. The Sheet-Metal1 feature contains the default bend parameters.

To edit the default bend radius, bend allowance or bend deduction, or default relief type:

  1. Under Sheet Metal Gauges, select Use gauge table, and select a table .

  2. Under Bend Parameters:

  • On the model, select a linear edge on an end face of a cylindrical or conical face, or select a planar face for Fixed Face or Edge .

The edge or face remains in place when the part is flattened.

This step is not necessary if you start your sheet metal part from a Base Flange feature.

  • Set the Bend Radius .

  1. Under Bend Allowance, select from the following: Bend Table , K-Factor , Bend Allowance , Bend Deduction , or Bend Calculation .

    • If you selected K-Factor, Bend Allowance, or Bend Deduction, set a value.

    • If you selected Bend Table or Bend Calculation, select a table from the list, or click Browse to browse to a table.

  2. If you want relief cuts added automatically, select Auto Relief, then select the type of relief cut. If you selected Rectangular or Obround, then you must set  a Relief Ratio.

  3. Click OK .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sheet Metal Default Bend Parameters
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21