Error Message - Check Sketch for Feature
The Check Sketch for Feature tool examines sketches for errors in contour that might prevent a feature from being created. It checks for error that are common to all contour types, and, if you select a feature type, it also checks the contour type required for the feature type. When errors are diagnosed, the problem geometry is highlighted.
This example checks a sketch for use in creating a Base Revolve feature.
To check a sketch:
-
In an open sketch, click Tools, Sketch Tools, Check Sketch for Feature.
-
For Feature Usage, select Base Revolve.
Multiple Disjoint Closed is displayed as the Contour type.
-
Click Check.
|

|
A diagnostic message is displayed, and the corresponding extraneous line is highlighted.
The sketch cannot be used for a feature because an endpoint is wrongly shared by multiple entities.
-
Delete the highlighted line.
-
Click Check again.
|

|
The same message appears and a different extraneous line is highlighted.
The sketch cannot be used for a feature because an endpoint is wrongly shared by multiple entities.
-
Delete the highlighted line.
-
Click Check again.
|

|
A new message indicates that the highlighted line is not connected to the intersecting lines.
The sketch has more than one open contour.
-
Trim one end of the line and extend the other end.
-
Click Check again.
|

|
Now all the errors have been found and corrected.
No problems found. The sketch contains 1 closed contour(s) and 0 open contour(s).
-
Click Close.
|

|
To create the base revolve feature:
-
Click Revolved Base/Boss (Features toolbar) or Insert, Base/Boss, Revolve.
-
Select the line shown as the axis of revolution.
|

|
-
Click to complete the feature.
|

|