Hide Table of Contents

Point-to-Point Dimensions

You can place a horizontal, vertical, or linear dimension between two sketch points, sketch segment endpoints, or model vertices. You can also use the model origin as a point. Select the two points, then move the pointer around to observe the dimension preview.

To create a dimension between two points:

  1. Click Smart Dimension (Dimensions/Relations toolbar) or Tools, Dimensions, Smart.

  2. Click one point.

  3. Click the other point.

  4. Move the pointer to show the dimension preview.

  5. Set the value in the Modify box and click .

  6. Click to place the desired dimension.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Point-to-Point Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21