Hide Table of Contents

Contact Resistance

The Apply to solid/solid only option in the Contact Resistance dialog box allows you to specify contact resistance only at overlapping parts of solid surfaces in contact.

In the Contact Resistance PropertyManager, select Apply to solid/solid only.

Flow_wn2012_Apply_Solid_Off Flow_wn2012_Solid_On
Apply to solid/solid only: OFF Apply to solid/solid only: ON
Parent topic: Pre-Processor


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Contact Resistance
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21