Hide Table of Contents

Align Balloons with Magnetic Lines

You can use magnetic lines to align balloons. You attach balloons to magnetic lines, choose to space the balloons equally or not, and move the lines freely at any angle. The balloons maintain their alignment when the magnetic lines are not visible. You can insert magnetic lines automatically when you use the Auto Balloon command. You can also insert balloons before or after inserting magnetic lines.

prj-17537-magnetic-line-intro-new.gif prj-17537-magnetic-line-intro-5.gif
Without Magnetic Line With Magnetic Line


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Align Balloons with Magnetic Lines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46