Use the Plated Hole Properties and Non-Plated Properties panels to view and edit plated and non-plated hole properties.
From the tree view, expand Boards, expand Plated Holes or Non-Plated Holes, then right-click the hole and select Properties.
| X Value (mm) |
X coordinate of the center point of the hole relative to the board's origin (typically the lower-left corner).
|
| Y Value (mm) |
Same as X Value but for the Y coordinate.
|
| Hole Diameter |
The hole diameter.
|
| Associated Part |
Read-only. The part with which the hole is associated: - Reference designator of a component instance
- BOARD
- PANEL
- NoRefDes (a component without a reference designator)
The hole filtering section of the Import Wizard uses this property to include or exclude holes by their associated component.
|
| Hole Type |
The use of the hole: - Pin - Associated with a component pin.
- Via - Associated with a conductive via.
- Mtg - Used for mounting purposes.
- Tool - Used for tooling purposes.
- Other - Has an alternative use.
|
| Hole Owner |
Not supported by all ECAD systems. Ignored by CircuitWorks (CircuitWorks can modify properties regardless of this property value), but you can change the value when exporting IDF data:
-
MCAD - Can only be modified in the MCAD system.
- ECAD - Can only be modified in the ECAD system.
- Unowned - Can be modified in either system.
|
| Filter Status |
The filter status: Filtered In or Filtered Out.
|