Hide Table of Contents

Circular Sketch Pattern PropertyManager

Create circular sketch patterns on a plane or on a model using sketch entities or model edges to define the pattern.

Parameters

PM_reverse_direction_circ.gif Reverse direction  
  Select a center for the pattern:

Sketch origin

Use the sketch origin (default).

Center X PM_Center_X_Coordinate.gif

Sets the pattern center along the X axis.

Center Y PM_Center_Y_Coordinate.gif

Sets the pattern center along the Y axis.
circular_sketch_pattern_origin.gif
Pattern center at sketch origin
circular_sketch_pattern_point.gif
Pattern center set along X and Y axes
PM_angle_a1.gif Spacing Sets the number of total degrees included in the pattern.
  Equal spacing Sets pattern instances equidistant from each other.
  Dimension radius Displays the circular pattern radius.
  Dimension angular spacing Displays the dimension between pattern instances.
PM_number of_instances_circ.gif Number of Instances Sets the number of pattern instances.
  Display instance count Shows the number of instances in the pattern.
PM_Radius.gif Radius Sets the radius of the pattern.
PM_Arc_Angle.gif Arc Angle Sets an angle measured from the center of the selected entities to the center point or vertex of the pattern.
arc_angle_01.gif
Arc Angle value set to default.
arc_angle_02.gif
Arc Angle value incremented by 20º.

Entities to Pattern

PM_entities_to_pattern.gif Entities to Pattern Select sketch entities in the graphics area.

Instances to Skip

Click Instances to Skip PM_instances_to_skip_circle.gif and with the pointer Pointer_InstancesToSkip.gif, select instances in the graphics area that you do not want to include in the pattern.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Circular Sketch Pattern PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.6