Hide Table of Contents

Polygon PropertyManager

You can control the following properties of sketched polygons.

Existing Relations

No relations exist for polygons.
PM_information.gif Information Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on).

Add Relations

You can only add relations to the points and lines of polygons.

Options

For construction Converts the entity to construction geometry.

Parameters

You can specify any appropriate combination of the following parameters to define the polygon. When you change one or more parameters, the other parameters update automatically.

PM_No_of_Sides_Polygon.gif Number of Sides Sets the number of sides in the polygon. A polygon can have 3 to 40 sides.
  Inscribed circle Displays an inscribed circle inside the polygon to define the size of the polygon. The circle is construction geometry.
  Circumscribed circle Displays a circumscribed circle outside of the polygon to define the size of the polygon. The circle is construction geometry.
PM_Center_X_Coordinate_Polygon.gif Center X Coordinate Displays the X coordinate for the center of the polygon.
PM_Center_Y_Coordinate_Polygon.gif Center Y Coordinate Displays the Y coordinate for the center of the polygon.
PM_Circle_Diameter_Polygon.gif Circle Diameter Displays the diameter of the inscribed or circumscribed circle.
PM_angle.gif Angle Displays the angle of rotation.
  New Polygon Lets you to create another polygon.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Polygon PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.6