Hide Table of Contents

Using Corner Treatments

When you flatten a sheet metal part by unsuppressing the Flat-Pattern feature, corner treatments are automatically applied to create a clean, flattened sheet metal part. The corner treatments are applied so the flat pattern is correct for manufacturing.

shm_flat_pattern1.gif
Model with a miter flange
shm_flat_pattern2.gif shm_flat_pattern3.gif
Flattened model without a corner treatment (using the Unfold Tool_Unfold_Sheet_Metal.gif feature) Flattened model with a corner treatment

To turn off corner treatments:

  1. In the FeatureManager design tree, right-click Flat-Pattern1, and select Edit Feature.
  2. In the PropertyManager, clear Corner treatment.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Corner Treatments
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21