Hide Table of Contents

Creating Custom Motor or Force Profiles

You can create custom motor or force profiles with the Function Builder.

To create a new motor or force profile, from a Motion Analysis study:

  1. Open the PropertyManager:
    • Click Force to create a new force profile.
    • Click Motor to create a new motor profile.
  2. Configure the options.
  3. For Type, select one of the following:
    Option Description
    Segments Defines profile from piecewise continuous functions of time or cycle angle.
    Data Points Defines profile from an interpolated data set as a function of time, cycle angle, or motion study results.
    Expression Defines profile as mathematical expression of time, cycle angle, or motion study results.

    The Function Builder appears.

  4. Specify options for the selected function type and click OK to close the Function Builder.
  5. Click .

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Creating Custom Motor or Force Profiles
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.