Hide Table of Contents

Grid System PropertyManager

You can use the Grid System tool to lay out a grid system for large structures.

To display this PropertyManager, start with a part or assembly. Click Grid System (Features toolbar). Create a sketch, then close the sketch in the Confirmation Corner.

Level Parameters

Number of levels Sets the number of levels (floors) in the structure.
Default height Sets the distance between each level.
  Height Overrides the Default height between individual levels.
  3DSketch Split Lines Splits the 3D sketch lines at each level in the structure. When cleared, the 3D sketch lines are continuous among the levels. It is helpful to keep the 3D sketch continuous if you create weldment structures.
Selected (split) Cleared (continuous)
  Autonumber Balloons Updates the balloon values if you change the base sketch.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Grid System PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.