Hide Table of Contents

Insert Line PropertyManager - 3D

Enables you to sketch multiple 3D lines.

Orientation

Only As sketched is available with 3D sketches.

As sketched With the click-drag method, sketch a line in any direction until you release the pointer.

With the click-click method, sketch a line in any direction, and continue sketching other lines in any direction, until you double-click.

Options

For construction Creates a construction line.
Infinite length Creates a line of infinite length that you can later trim.
Once you sketch a line, the Insert Line PropertyManager changes to the Line Properties PropertyManager, and you can continue sketching 3D lines. To change Options, click PM_OK.gif to return to the Insert Line PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Insert Line PropertyManager - 3D
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.