Hide Table of Contents

Path Properties PropertyManager

In Edit Sketch mode, select sketch entities with an existing path to display the Path Properties PropertyManager.


Existing Relations

Displays relations between the sketch entities that make up a path and the sketch entities with which the path interacts. For example, a cam (sketch entities that make up a path) and its follower interact and list a tangent relation.


Click Edit Path to:
  • Add sketch entities to create a path. This occurs after you select a sketch entity and click Make Path Tool_Make_Path_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Make Path.
  • Display the sketch entities that make up an existing path.
  • Select sketch entities to highlight them in the graphics area.
  • Remove sketch entities from the path.
    If the sketch entity you remove breaks the chain of sketch entities, you must recreate the path.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Path Properties PropertyManager
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.