Contents
You can place an angular dimension between three sketch points, sketch segment endpoints, or model vertices. You can also use the model origin as one of the three points.
You can place an angular dimension between two lines or a line and a model edge. Select the two entities, then move the pointer to observe the dimension preview. The angle to be dimensioned changes based on the pointer position.
Provide feedback on this topic
SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.
* Required
Thank you for your comments. We will contact you if we have questions regarding your feedback.
Sincerely,The SOLIDWORKS Documentation Team
Print Topic
Select the scope of content to print:
We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.
Web Help Content Version: SOLIDWORKS 2013 SP05 To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help. To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.