> Assemblies > Controlling Display and Appearance in Assemblies

Introduction

Administration

User Interface

SolidWorks Fundamentals

Moving from 2D to 3D

Assemblies

The FeatureManager Design Tree in an Assembly

Basic Component Operations

Design Methods (Bottom-up and Top-down Design)

Top-Down Design

Mates

Subassemblies

Controlling Display and Appearance in Assemblies

External Files

Detecting Problems

Exploded Views in Assemblies

Other Assembly Techniques

Design Studies in SolidWorks

Detailing and Drawings

Sustainability Products

Controlling Display and Appearance in Assemblies

Contents

Controlling the Display of Assemblies

You can toggle the display of assembly components. You can remove the component completely from view or make it 75% transparent. Turning off the display of a component temporarily removes it from view, allowing you to work with underlying components.
Appearance in Assemblies
Display States in Assemblies
Display States versus Configurations in Assemblies
Display Pane in Assemblies

Parent topic

Assemblies

Search 'Controlling Display and Appearance in Assemblies' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Controlling Display and Appearance in Assemblies
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

Just this topic
This topic and only immediate topics under it (up to 6 topics)
This selected topic and all subtopics (up to 15 topics)

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.