Hide Table of Contents

Changing the Origin Location and Orientation

You can change the origin location and orientation in blocks.

To change the origin location or orientation:

  1. Create blocks from several sketch entities.


  2. In the FeatureManager design tree, right-click a Block FM_block_sketch.gif and select Edit Block.

    The origin and orientation changes for each block.

    blocks_origin-orientation02.gif blocks_origin-orientation03.gif blocks_origin-orientation04.gif

  3. Click Tools > Sketch Tools > Align > Align Grid/Origin.
  4. In the Align Grid/Origin PropertyManager, under Selections:
    • To change only the sketch origin:

      Select a vertex or point for Sketch Origin Location PM_sketch_origin_location.gif.

    • To change both the sketch and orientation:
      Click in X-axis or Y-axis, and select a line to change the orientation of the sketch origin.
      You can select internal or external sketch entities as references to define both the orientation and the location along the X or Y axis.
  5. Click PM_OK.gif.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Changing the Origin Location and Orientation
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.