Hide Table of Contents

Creating Multiple Point Splines

Splines can have two or more points.

To create multiple point splines:

  1. Click Spline Tool_Spline_Sketch.gif (Sketch toolbar) or Tools > Sketch Entities > Spline.

    The pointer changes to pointer4spline.gif.

  2. Click to place the first point and drag out the first segment.
  3. Click the next point and drag out the second segment.
  4. Repeat for each segment, then double-click when the spline is complete.


    The Spline PropertyManager appears.

    Spline handles display by default. To hide or display spline handles, click Show Spline Handles Tool_Show_Spline_Handles_Spline_Tools.gif (Spline Tools toolbar) or Tools > Spline Tools > Show Spline Handles .

  5. Click PM_OK.gif.

    Video: Creating Multiple Point Splines

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Creating Multiple Point Splines
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.