Hide Table of Contents

Creating Virtual Sharps

A virtual sharp creates a sketch point at the virtual intersection point of two sketch entities. Dimensions and relations to the virtual intersection point are retained even if the actual intersection no longer exists, such as when a corner is removed by a fillet or chamfer.

Virtual sharps appear automatically in 3D sketches for:
  • Fillets
  • Sketch Chamfers

You can delete the automatic virtual sharps.

You can add dimensions and relations to virtual sharps in 3D sketches.

To create a virtual sharp:

  1. In an open sketch, hold down Ctrl and select two sketch entities.
  2. Click Point Tool_Point_Sketch.gif (Sketch toolbar) or click Tools > Sketch Entities > Point.

    A virtual sharp appears at the point where the sketch entities would intersect.

    Set the virtual sharp display style in Tools > Options > Document Properties > Virtual Sharps.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Virtual Sharps
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.