Hide Table of Contents

Sketching with Extruded or Revolved Bosses/Bases

To start a sketch with an Extruded or Revolved Boss/Base:

  1. Click Extruded Boss/Base Tool_Extruded_Boss_Base_Features.gif or Revolved Boss/Base Tool_Revolved_Boss_Base_Features.gif on the Features toolbar, or click Insert > Boss/Base > Extrude or Boss/Base > Revolve .
  2. Select one of the three planes (Front Plane, Top Plane, and Right Plane) displayed.

    In new parts, the plane rotates to the Normal to orientation.

  3. Create a sketch with the sketch entity tool, or select a tool on the Sketch toolbar and create a sketch.

    The sketch must be a closed sketch.

  4. Close the sketch to open the PropertyManager of the feature you selected.
  5. Create the part and click PM_OK.gif.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Sketching with Extruded or Revolved Bosses/Bases
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.