Hide Table of Contents

Viewing Problem Mates

You can display a list of all the problem mates in an assembly. Select mates from the list to display mate callouts.

To display a list of problem mates:

  1. Do one of the following:
    • Right-click any component containing a problem mate and click View Mate Errors.
    • Click the mate status ( Over Defined or No Solution Found) in the status bar.

    The View Mate Errors window appears.

    In the graphics area, components involved in the problem mates are slightly transparent. Components not involved are hidden.

  2. In the window:
    1. Move the pointer over a mate.

      A tooltip describes the mate warning or error. The mate geometry highlights in the graphics area.

    2. Select one or more mates.

      Callouts appear for the selected mates. Each mate has one callout, with leaders pointing to the mated entities.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Viewing Problem Mates
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.56