Hide Table of Contents

Accessing the SelectionManager

To access the SelectionManager:

  1. Activate a supported tool (loft, sweep, or boundary surface).
  2. Do one of the following:
    • Select a sketch entity.
      If the entire selected 2D or 3D sketch is valid as the selected parameter, the SelectionManager does not appear. For example, if a 3D sketch contains multiple entities that together are valid as a guide curve, and you select that 3D sketch as a guide curve, the SelectionManager does not appear.
    • Right-click and choose SelectionManager.
When the SelectionManager is active, the Confirmation Corner changes to, which allows you to accept the selection and exit, or to cancel the SelectionManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Accessing the SelectionManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.