Hide Table of Contents

Displaying Curvature and Radius Values

To display curvature and radius values:

  1. Click Options Tool_Options_Standard.gif (Standard toolbar), or click Tools > Options.
  2. On the System Options tab, click Display/Selection.
  3. Select Dynamic highlight from graphics view, then click OK.

    Now when the Curvature tool is active, the curvature and radius values display beside the pointer when you point to a model surface or a sketch entity (such as a spline or curve).

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Displaying Curvature and Radius Values
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.