> Design Checker > Feature Checks Overview > Suppressed Feature

Introduction

Administration

User Interface

SolidWorks Fundamentals

Welcome to SolidWorks Design Checker

Design Checker Tools

Document Checks Overview

Annotation Checks Overview

Dimension Checks Overview

Drawing Document Checks Overview

Part Document Checks Overview

Assembly Document Checks Overview

Feature Checks Overview

Feature Error Warnings

Fully Defined Sketch

Standard Hole Size

Suppressed Feature

Feature Positioning Check

Design Studies in SolidWorks

Detailing and Drawings

Sustainability Products

Suppressed Feature

Cycles through all features and model configurations for suppressed parts.

For Suppressed Components

, and Suppressed Features

The check fails only if the condition exists in all configurations.
Setting the Criticality level is the only user interface.

Parent topic

Feature Checks Overview

Related reference

Feature Error Warnings

Fully Defined Sketch

Standard Hole Size

Feature Positioning Check

Search 'Suppressed Feature' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Suppressed Feature
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.